How to Convert Degrees and Radians in Geometry
By Prince Yadav, Founder & Lead Developer.
Both units describe the same angle
Degrees divide a full turn into 360 parts. Radians describe an angle through the ratio of arc length to radius, making them especially useful in mathematics and physics.
Remember the full-turn relationship
A full turn is 360 degrees or 2π radians; a straight angle is 180 degrees or π radians. Therefore, degrees convert to radians by multiplying by π/180.
Example: 90 degrees
Ninety degrees equals π/2 radians, approximately 1.5708 radians. The exact form involving π can be preferable in symbolic mathematics.
Check calculator mode
Trigonometric functions may expect degrees or radians depending on the calculator mode. Entering an angle in the wrong mode can produce a plausible-looking but incorrect answer.
Keep exact and rounded forms distinct
A value such as π/3 is exact, while 1.0472 is a rounded decimal approximation. Keep extra digits when further calculations depend on the value.
Use the right convention for the task
Navigation, school geometry, calculus, engineering, and programming may use different default conventions. Check the formula or software documentation before interpreting the result.
Check angle units at the point of calculation
Many trigonometric calculators can interpret the same input as degrees or radians. For example, sin(30°) equals 0.5, while sin(30 radians) is a different value. A correct-looking input can therefore produce a surprising result if the calculator mode is wrong.
Before using sine, cosine, or tangent, confirm the displayed angle mode and write the unit beside the angle. In a full turn, 360° equals 2π radians; 180° equals π radians.
In geometry, engineering, and programming, keep the unit explicit through the calculation. If a result will be used in a design or measurement, verify the expected convention and avoid rounding intermediate angles unnecessarily.
Choose the unit before entering the value
A value of 1.2 means different things depending on the unit: 1.2 degrees is a very small angle, while 1.2 radians is about 68.8 degrees. The number alone is not enough; the unit and the calculator’s mode must agree.
For a conversion, use the full-turn relationship: 180° = π radians. To convert degrees to radians, multiply by π/180. To convert radians to degrees, multiply by 180/π. Keep π in the calculation when possible and round only the displayed answer.
- Check whether a scientific calculator is in DEG or RAD mode before using sine, cosine, or tangent.
- Use the unit expected by the assignment, engineering drawing, or software interface.
- When comparing answers, check the unit before assuming one result is wrong.
Related Calculators
Try the Calculator
Test the worked-example inputs in Angle Converter, then change one input to see how the result responds.
Open Angle Converter